BS홀딩스 - Riftek사 한국 공식대리점

측정 제품군 > 철도용 측정 제품군 > 철차바퀴 직경 측정 게이지

3D Laser system for large diameter pipes measurement

The system is designed for non-contact measurement of geometrical parameters (diameter, roundness, curvature) of large diameter pipes.
Technical characteristics of the system can be changed for a specific task.

Models

Specifications

Operation

Video

Downloads

3D Laser system for large diameter pipes measurement MRT1420-RF1420TB

Pipes Nominal Diameter (mm)

450...1525

Measurement Accuracy (mm)

±0.15

Pipe Length (m)

9...18.5

throughput (pipes/hours)

3D Laser system for large diameter pipes measurement MRT1420-RF1420TB

Pipes Nominal Diameter (mm)

450...1525

Measurement Accuracy (mm)

±0.15

Pipe Length (m)

9...18.5

throughput (pipes/hours)

3D Laser system for large diameter pipes measurement MRT1420-RF1420TB

Parameter	Value
Type of measurements	Diameter, roundness, ucrvature of the pipe, length of the pipe.
Number of measurement points of the pipe profile (in transverse section)	Up to 24000 (the entire pipe profile is to be measured using 2D laser scanners), number of scanners: 24
Method of measurement Profile	Laser Triangulation
Measurement Frequency Diameter, roundness Pipe profile	Up to 250Hz
Measurement Accuracy Outer diameter Inside diameter Total straightness (pipe warping) Deviation from pipe ends straightness on the basis of 1m Deviation from theoretical girth Pipe ends roundness Pipe body roundness Bevel angle Thickness of the pipe wall Pipe cutting edge Bevel dulling Welded edges displacement Deviation from theoretical girth Weld height Weld width	Not worse than ± 0.15mm Not worse than ± 0.15mm Not worse than ± 1mm Not worse than ± 0.1mm Not worse than ± 0.3mm Not worse than ± 0.3mm Not worse than ± 0.3mm Not worse than ± 0.5° Not worse than ± 0.1mm Not worse than ± 0.15mm Not worse than ± 0.15mm Not worse than ± 0.1mm Not worse than ± 0.1mm Not worse than ± 0.3mm
Test Speed (m/s)	Up to 1.5
Uncontrolled zones in the beginning and end of the pipe at a speed of 1m/s Diameter, roundness	Not more than 10mm

3D 레이저 스캐닝 원리를 기반으로 작동

RFMR625 레이저 스캐너 24개가 움직이는 파이프 주위에 배치되어 전체 3D 모델을 얻고 직경과 진원도를 계산.

RFMR625 레이저 스캐너 10개가 이동 파이프를 따라 배치되어 파이프 곡률을 계산.

3D Laser system for large diameter pipes measurement

3D Laser system for large diameter pipes measurement (5MB)